FP302 Intustrap Intumescent Strap

FP302 Intustrap is 25 metre roll of rubber based product with graphite impregnation, used as a fire stopping closer device.

Usage/purpose

FP302 Intustrap is a tested and proven closer device to be used around combustible pipes (insulated and not insulated), insulated non-combustible pipes, and conduits (filled or empty).

FP302 is suited to a range of combustible elements
FP302 has been tested direct within Rigid Walls / Floors, White Walls, CLT Walls / Floors, Trapezoidal Deck Floors and FR230 Intucompound.

FP302 has been tested within FB750 Intubatt or FB770 Intudeck in Flexible Walls, Rigid Walls / Floors and Timber Floors.

Typical areas of use include: health and leisure facilities, schools, universities, modular construction, commercial buildings, hospitals, retail and industrial units, train stations, nuclear power plants, etc...

Always read SDS, pre-application guidance and relevant application detail prior to application. Ensure the latest documents are downloaded prior to every project commencement.

FP302 is tested with inspection in mind. The product should protrude from all substrates by a maximum of 10mm. This enables easy inspection.
FP302 may also be installed anywhere within the floor slab, up to 300mm from the underside of the soffit. We recommend installation is either at the top or the bottom face to prevent destructive inspection requirements.
Do not use around CPVC pipes; for this specific application, please use FS719 HP Blue for CPVC.
If used around Pegler X-Press Carbon steel pipes, the pipe manufacturer should be consulted and their recommendations followed.
When using FR230, if the service type requires thermal expansion, FP302 should be the full depth of the FR230 primary seal if an alternative thermal accommodation joint has not been used.
The product is tested with or without the release tape in position, so it can be used with or without the tape present.

Safety data sheet must be read and understood before use.